Variable visability, hidden units question

[Montana Grizz]

I've noticed that when I highlight my opponents visable units that some that use to be visable under pre-1.03 are not highlighted.

However, when I cycle through the fire phase sometimes a unit of mine will say that it can fire, but I can't see a highlighted unit to fire at.

If I scroll my cursor around it will show an enemy unit that I can fire at, but isn't highlighted?

Is this a glitch? Hardly a hidden unit if it isn't highlighted, but can be located?

Thank you,

Pat

[Kool Kat]

I've noticed that when I highlight my opponents visable units that some that use to be visable under pre-1.03 are not highlighted.

However, when I cycle through the fire phase sometimes a unit of mine will say that it can fire, but I can't see a highlighted unit to fire at.

If I scroll my cursor around it will show an enemy unit that I can fire at, but isn't highlighted?

Is this a glitch? Hardly a hidden unit if it isn't highlighted, but can be located?

Thank you,

Pat

Pat:

Are any of these affected units Anti-Tank units? :conf:

I know that in ver. 1.03 and incorporated into ver. 1.04, was the Hidden Anti-Tank rule. This provides small anti-tank guns (57mm – 6pdr or SMALLER) a 50% chance to remain hidden when it fires. This also applies to Bazooka/Panzerfaust/AT Rifles. :chin:

[Von Earlmann]

it also might be that the unit is spotting the muzzle flash and is firing at that......see the manual for a full explanation.