 |
|
Variable visability, hidden units question - Printable Version +- Forums (https://www.theblitz.club/message_boards) +-- Forum: The Firing Line (https://www.theblitz.club/message_boards/forumdisplay.php?fid=1) +--- Forum: Campaign Series (https://www.theblitz.club/message_boards/forumdisplay.php?fid=8) +--- Thread: Variable visability, hidden units question (/showthread.php?tid=47748) |
Variable visability, hidden units question - Montana Grizz - 08-26-2008 I've noticed that when I highlight my opponents visable units that some that use to be visable under pre-1.03 are not highlighted. However, when I cycle through the fire phase sometimes a unit of mine will say that it can fire, but I can't see a highlighted unit to fire at. If I scroll my cursor around it will show an enemy unit that I can fire at, but isn't highlighted? Is this a glitch? Hardly a hidden unit if it isn't highlighted, but can be located? Thank you, Pat RE: Variable visability, hidden units question - Kool Kat - 08-27-2008 Montana Grizz Wrote:I've noticed that when I highlight my opponents visable units that some that use to be visable under pre-1.03 are not highlighted. Pat: Are any of these affected units Anti-Tank units? :conf: I know that in ver. 1.03 and incorporated into ver. 1.04, was the Hidden Anti-Tank rule. This provides small anti-tank guns (57mm – 6pdr or SMALLER) a 50% chance to remain hidden when it fires. This also applies to Bazooka/Panzerfaust/AT Rifles. :chin: RE: Variable visability, hidden units question - Von Earlmann - 08-27-2008 it also might be that the unit is spotting the muzzle flash and is firing at that......see the manual for a full explanation. |
){kind=link}