English tanks wont not move?

[Hadge]

Oh ja it s workt!
Now I can see the German unit too!

Thanks a loots!

I have one question.
Recon spotting will work in Travel Mode?

Hi,

I have just done a very quick test and recon spotting can be done by a unit in Travel mode - I would be careful as any return opportunity fire will be more effective as your spotting unit is in T mode.

I'm not sure if being in travel mode makes any difference to the effectiveness of the spotting attempt - I suspect no difference - but I'm not sure.

C

[ComradeP]

If you can't assault when you select a unit or stack and click on the target hex, you may have found a bug.

You shouldn't have to do it in the difficult way wildb wrote down.

[Compass Rose]

Is this the correct scenario?

#0802_01: Kampfgruppe Fröhlich - German Ingenuity


If so, I just ran two tests and I was able to move British armor into objective hex (8,10) both in "T" mode and also while deployed, with no problem.

I did however, find it interesting that it is only a 8 turn scenario and the British has no units on the map until turn 2.

Has anyone else noticed that also?

It as if the British side only has 7 turns while the German side has 8 turns.

[Beerweasel]

Oh ja it s workt!
Now I can see the German unit too!

Thanks a loots!

I have one question.
Recon spotting will work in Travel Mode?

https://www.youtube.com/watch?v=rL9-Va6_SVY

This also helps, around the 3 min mark.............

[ComradeP]

Has anyone else noticed that also?

It as if the British side only has 7 turns while the German side has 8 turns.

There are a number of small scenarios where one side is likely to run out of time, though in this case the units involved are small which gives you some chance of removing them from the hexes they hold before time runs out and the side likely to run out of time is the Axis.

The victory conditions are also not too harsh, as if you remove the pionier unit from the 25 point objective it is likely to capture before you get there, you've won unless you end up losing all your tanks somehow.

[O.Schmidt]

Is this the correct scenario?

#0802_01: Kampfgruppe Fröhlich - German Ingenuity


If so, I just ran two tests and I was able to move British armor into objective hex (8,10) both in "T" mode and also while deployed, with no problem.

I did however, find it interesting that it is only a 8 turn scenario and the British has no units on the map until turn 2.

Has anyone else noticed that also?

It as if the British side only has 7 turns while the German side has 8 turns.

Hi Compass Rose!
I can not enter the hex 10,11 also not in the "T" mode!
I will attachment the file! (Look below)
---------------
It work only in ths way!
Try this:
Highlight the hex.
Select Assault Menu - Begin Assault
Select Assault Menu - Add to Assault - Select one of the tank units
Select Assault Menu - Resolve Assault

[O.Schmidt]

https://www.theblitz.club/uploads/files/...I_2801.zip

[ComradeP]

Works fine for me, using that file.

How are you trying to enter the hex? If you're using drag-and-drop movement, units can't enter the hex and you'll get a "can't move into hex containing enemy units" error in the lower left of the interface.

If you select a unit and attempt to move into the hex through normal movement by clicking once, you'll get an assault pop-up.

[Ricky B]

And to clarify since it appears O.Schmidt is not using the click method - select any adjacent unit, right click on the objective and you will see a message regarding Unknown Assault Odds. That will set up an assault, required to attempt to remove the enemy unit and enter the hex. Of course, with units around 4 sides of the hex, the hidden enemy unit can't be forced out and must be destroyed. After the assault is resolved, the enemy unit will be visible also.

Rick

[O.Schmidt]

I thought if a unit is adjacent to an enemy unit Is this visible!

I have not yet understood this correctly click system!

"I must now ins maneuver because I have to learn a lot!"

Thank for the help!